EverFocus EQ550 ユーザーズマニュアル
- 29 -
7.8 Alarm output for motion detected
First, please set Motion detection ON in Setup Menu (Special -> Motion Det -> ON). When a
motion is detected, not only the message “MOTION DETECTED” appears on the screen, but
the camera also sends out a high level of 3V signal to alarm output. If no motion has been
detected, a low level of 0V signal will be sent out to alarm output.
motion is detected, not only the message “MOTION DETECTED” appears on the screen, but
the camera also sends out a high level of 3V signal to alarm output. If no motion has been
detected, a low level of 0V signal will be sent out to alarm output.
8
7
6
5
1
2
4
3