Sony DSC-U50 マニュアル
68
Shooting still images/movies
You cannot turn on the
camera.
camera.
• The batteries are not installed correctly.
• The batteries are discharged.
• The batteries are dead (page 83).
• The batteries are discharged.
• The batteries are dead (page 83).
p Install the batteries correctly (page 12).
p Replace them with charged batteries (page 10).
p Replace the batteries with new ones.
p Replace them with charged batteries (page 10).
p Replace the batteries with new ones.
The power turns off
suddenly.
suddenly.
• If you do not operate the camera for about three
minutes when using batteries, the camera turns
off automatically to prevent wearing down the
batteries (page 15).
off automatically to prevent wearing down the
batteries (page 15).
• The batteries are discharged.
p Turn on the camera again (page 14).
p Replace them with charged batteries (page 10).
Symptom
Cause
Solution
Symptom
Cause
Solution
The subject does not appear
on the LCD screen.
on the LCD screen.
• The mode switch is set to
.
p Set the mode switch to
or
The image is out of focus.
• The subject is too close.
• When shooting still images,
(Illumination
snap mode),
(Twilight mode),
(Vivid
nature mode), or
(Active outdoor mode) is
selected for the Scene Selection function.
• You are shooting movies at a distance closer
than 1.0 m (3 feet 3 3/8 inches).
• The Focus preset function is selected.
p Make sure to position the lens farther away from the subject
than the minimum shooting distance of 10 cm (4 inches) when
shooting (page 20).
shooting (page 20).
p Cancel the Scene Selection function (page 29).
p Select the Focus preset function (page 30).
p Set it to [AUTO] (page 31).
The image is too dark.
• The LCD screen is too dark.
The image is too bright.
• The LCD screen is too bright.
Vertical streaks appear
when you are shooting a
very bright subject.
when you are shooting a
very bright subject.
• The smear phenomenon is occurring.
p This is not a malfunction.