Panasonic DMC-GF1K ユーザーズマニュアル
17
VQT2G62
Preparation
∫ Optical Image Stabilizer
The Optical Image Stabilizer function is set for activation when the lens is attached to the
camera body.
The Optical Image Stabilizer function is set for activation when the lens is attached to the
camera body.
Set the [O.I.S.] switch to [ON].
•
You can change the Optical Image Stabilizer mode to
[MODE1], [MODE2] or [MODE3] using [STABILIZER] in
the [REC] mode menu. (P118) It is set to [MODE1] at the
time of purchase.
•
We recommend setting the [O.I.S.] switch to [OFF] when
using a tripod. If the [O.I.S.] switch is set to [OFF], [
]
is displayed on the LCD monitor/optional external
viewfinder.
Attach the lens cap.
Press the lens release button D while
turning the lens as far as possible in the
direction of the arrow to detach it.
•
Always attach the body cap to the camera body so
that dirt or dust does not get inside.
•
Attach the lens rear cap so that the lens contact
point does not get scratched.
Note
•
Change lenses where there is not a lot of dirt or dust. Refer to P172 when dirt or dust gets on
the lens.
•
When you turn the camera off or carry the camera, attach the lens cap to protect the surface of
the lens.
•
Be careful not to lose the lens cap, the lens rear cap and the body cap.
A lens which supports the stabilizer function is required.
–
The 20 mm/F1.7 interchangeable lens supplied with the DMC-GF1C does not support
the stabilizer function.
–
The 14-45 mm/F3.5-5.6 interchangeable lens supplied with the DMC-GF1K supports the
stabilizer function.
Detaching a lens from the camera body
DMC-GF1GN-VQT2G62_eng.book 17 ページ ２００９年８月２０日 木曜日 午前１１時７分