Panasonic HDC-Z10000P ユーザーズマニュアル
60
VQT3U98
To remove the external microphone, etc., from the audio input terminals 1, 2
(XLR 3 pin)
(XLR 3 pin)
Remove while pushing on the PUSH section of the audio
input terminals 1, 2 (XLR 3 pin).
≥ Set the input signal to built-in microphone by switching
input terminals 1, 2 (XLR 3 pin).
≥ Set the input signal to built-in microphone by switching
the CH1, CH2 switches to INT (L) or INT (R) after
removing the external microphone. Audio will not be
recorded when motion picture is recorded without
switching.
removing the external microphone. Audio will not be
recorded when motion picture is recorded without
switching.
≥ Set INPUT1,2 (+48V) switches to OFF if you connect equipment not compatible with
+48 V. You can damage this unit or such equipment if you leave the setting at ON.
≥ This unit is turned off when a problem occurs with the +48 V power supply.
≥ The battery will discharge faster if you use a phantom microphone.
≥ When inputting the external microphone signal to audio channels 1 and 2, connect the
≥ The battery will discharge faster if you use a phantom microphone.
≥ When inputting the external microphone signal to audio channels 1 and 2, connect the
external microphone to audio input2 terminal (XLR 3 pin) and switch both CH1 and CH2
switches to INPUT2.
switches to INPUT2.
ヱヶヴラ
A PUSH section
HDC-Z10000P-VQT3U98_mst.book 60 ページ ２０１１年１０月４日 火曜日 午後３時２分