AGFA 307 ユーザーズマニュアル

The ActionCam PC version bundles the AVA™1502P SCSI host
Adapter from ADAPTEC.  The AVA™1502 P is a 16 bit Plug and Play
ISA to SCSI host adapter for DOS and Windows systems. This board is
choosen because of  his easy installation capabilities (plug-and-play)
and his external DB25 connection.  The external connector  can be
directly connected to the ActionCam SCSI cable. The SCSI board
supports asynchronous data transfer up to 2Mbytes/sec. which is
sufficient for the Actioncam camera.  Another advantage is that only
one external SCSI device is supported so that no SCSI ID conflicts can
occur.

Follow these steps to install the AVA-1502P SCSI adapter in your
system.

1.

Remove the cover of your computer.

2.

Locate an unused 16 bit ISA expansion slot.

3.

Remove the corresponding slot cover from the back of your
computer chassis.  Keep the screw that held the cover on place.

4.

Carefully remove the host adapter from its package.

5.

Align the host adapter with the ISA bus and press it into the
slot.

6.

Attach the host adapter bracket to the computer chassis, using
the screw from the expansion slot cover you have removed in
step 3.

7.

Attach the 25-pin side of the SCSI cable to the connector on the
host adapter.

8.

Attach the other side of the SCSI cable (high density SCSI-2) to
the ActionCam camera connector.

9.

Replace the computer chassis cover, following the instructions
in your computer's documentation.

10. Reconnect the power connector to the computer.