Zebra Technologies radio frequency identification (rfid) ユーザーズマニュアル
RFID Printer Setup and Operation
Set Tag Type
Set Tag Type
18
58978L-008 Rev. A
RFID Programming Guide
11/14/2008
Set Tag Type
After you select a transponder type and purchase labels, set the transponder (tag) type on the
printer. Do this through the control panel menu (see
printer. Do this through the control panel menu (see
) or
through the
^RS
Set RF Power Levels
Each transponder has specific radio frequency (RF) power setting requirements for read and
write operations, which define how much power is necessary to “energize” the transponder in
its targeted encoding field. The tag type that you are using must match the RFID power
settings of the printer. If necessary, you can change the power settings:
write operations, which define how much power is necessary to “energize” the transponder in
its targeted encoding field. The tag type that you are using must match the RFID power
settings of the printer. If necessary, you can change the power settings:
•
through the control panel (see
)
•
through the
^RW
)
•
through SGD commands (see
•
•
•
)
Perform RFID Transponder Calibration
If you are using RFID labels that were designed to meet the specifications of your printer, you
do not need to perform RFID transponder calibration. The printer will automatically place the
labels in the optimal programming position. For transponder placement specifications, go to
do not need to perform RFID transponder calibration. The printer will automatically place the
labels in the optimal programming position. For transponder placement specifications, go to
If you are using RFID labels that were not designed for your printer, you may need to perform
an RFID transponder calibration to determine the optimal programming position for your
media. You can perform this calibration through the
an RFID transponder calibration to determine the optimal programming position for your
media. You can perform this calibration through the
RFID TAG CALIB
control panel
) or through the
^HR
ZPL command (see
). To return to the default programming position at any time, use the
RESTORE option in the
RFID TAG CALIB