Zebra Technologies radio frequency identification (rfid) ユーザーズマニュアル
95
ZPL II Commands for RFID
^RE
11/14/2008
RFID Programming Guide
58978L-008 Rev. A
^RE
Enable/Disable E.A.S. Bit
Description Use this command to enable or disable the Electronic Article Surveillance
(E.A.S.) bit that is available in some ISO15693 tags (such as Philips). This command works
only on those ISO15693 transponders and will be ignored if the tag does not support E.A.S.
(E.A.S.) bit that is available in some ISO15693 tags (such as Philips). This command works
only on those ISO15693 transponders and will be ignored if the tag does not support E.A.S.
Format ^REt,r
The following table identifies the parameters for this format.
Important •
This command is not supported by all printers or firmware. See
for the list of printers and firmware with which you can
use this command.
Parameters
Details
t =
Enable/disable
the
E.A.S. bit in the
ISO15693
transponder
ISO15693
transponder
Accepted values:
N =
Disable E.A.S.
Y =
Enable E.A.S.
Default value: N
r
= number
of
retries
Accepted values: 0 to 10
Default value: 0
Example •
This example enables the E.A.S. bit in the transponder. It will retry the command
five times if necessary.
^XA
^REy,5
^XZ
^REy,5
^XZ