Enterasys Networks X009-U ユーザーズマニュアル
Attaching Cables, Installing Compact Flash Card and DIMM Upgrade Kit
Matrix X4-C Chassis Installation Guide 3-33
Installing the Memory Upgrade Kit
The following sections describe how to upgrade the Dual In‐line Memory Modules (DIMMs) on
the X‐CM‐00 Control Module from 1 GB (two 512 MB DIMMs) to 4 GB using the two 2 GB
SDRAM DIMMs included in the X‐4G‐MEM Memory Upgrade Kit. Both 2 GB DIMMs in the
Memory Upgrade Kit must be installed at the same time.
the X‐CM‐00 Control Module from 1 GB (two 512 MB DIMMs) to 4 GB using the two 2 GB
SDRAM DIMMs included in the X‐4G‐MEM Memory Upgrade Kit. Both 2 GB DIMMs in the
Memory Upgrade Kit must be installed at the same time.
Removing the DIMMs
1.
Locate the ESD wrist strap shipped with the Matrix X4‐C chassis. Attach the ESD wrist strap
to your wrist and plug the cable from the ESD wrist strap into the ESD grounding receptacle
at the bottom of the chassis as shown in
to your wrist and plug the cable from the ESD wrist strap into the ESD grounding receptacle
at the bottom of the chassis as shown in
.
2.
Disconnect any cabling on the CM and remove the CM from the chassis, placing it on a clean,
dry surface. Refer to “
dry surface. Refer to “
3.
Figure 3-30 Locating the DIMMs on the CM
4.
Push the connector arms away from the first DIMM, as shown in
, and remove the
DIMM.
Caution: Only qualified personnel should perform installation procedures.
Precaución: Solamente personal calificado debe realizar procedimientos de instalacion.
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones de
seguridad para evitar descargas de electricidad estática.
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones de
seguridad para evitar descargas de electricidad estática.
1 DIMMs (Dual In-line Memory Modules)