Panasonic AG-HPX600EN ユーザーズマニュアル

– 35 –

This section describes the basic procedures for shooting and recording. Before you actually start shooting, pre-inspect your system to see ensure that it 
works properly. (page 154)

If the battery charge is low, replace with a fully charged battery.

@

@

 tIf a low battery charge level is indicated even after replacing 

with a fully charged battery, make sure that the battery has 

been inserted correctly. (page 130)

When two P2 cards are inserted in the P2 card slots, the P2 card with 
the smaller slot number will be recorded to first. Note, however, that 
regardless of the slot number, if a P2 card is inserted later, that P2 
card will not be accessed until the previously inserted P2 card has 
been recorded to.

 

f

Example: When P2 cards are inserted in two slots
If both slots contain P2 cards, the P2 cards are recorded in order 
slot number 1 → 2. However, if the P2 card is slot number 1 is 
removed and then re-inserted, the P2 cards will be used in the 
following order: slot number 2 → 1.

1

2

Note that the recording P2 card number is held even if the power 
is turned off, and when the power is next turned on, recording will 
continue on the same P2 card written before powering off.

After turning on the power and inserting the P2 card, set the switches as follows before starting to use the camera.

The [Y GET] function is assigned in the factory setting.

Normally, set this to <L> (0 dB). If conditions are too dark, set gain to 
an appropriate value.

Set this switch to CAM.AUTO KNEE ON.

For shooting, use the following steps.