Ricoh WG-20 ユーザーズマニュアル
237
7
Se
ttings
ttings
Pixel mapping is a function for mapping out and correcting for defective
pixels in the CCD sensor. Run the Pixel Mapping function if image dots
always seem to be defective in the same place.
pixels in the CCD sensor. Run the Pixel Mapping function if image dots
always seem to be defective in the same place.
1
Press the 3 button in A mode, and then press the
four-way controller (5) once.
four-way controller (5) once.
The [W Setting] menu appears.
2
Use the four-way controller (23) to select [Pixel
Mapping].
Mapping].
3
Press the four-way controller (5).
The [Pixel Mapping] screen appears.
4
Use the four-way controller
(2) to select [Pixel Mapping].
(2) to select [Pixel Mapping].
5
Press the 4 button.
Defective pixels are mapped and corrected.
Perform Pixel Mapping
• Pixel Mapping is only available in A mode. Pixel mapping cannot be
selected even if the [W Setting] menu is displayed by pressing the
3 button in Q mode.
3 button in Q mode.
• When executing Pixel Mapping from Q mode, press the Q button
once to enter A mode. Then press the 3 button and the four-
way controller (5) to display the [W Setting] menu and select Pixel
Mapping.
way controller (5) to display the [W Setting] menu and select Pixel
Mapping.
• Pixel Mapping cannot be selected in Voice Recording mode.
When the battery level is low, [Not enough battery power remaining to
activate Pixel Mapping] is displayed on the monitor. Use the AC adapter
kit K-AC117 (optional) or use a battery with ample capacity remaining.
activate Pixel Mapping] is displayed on the monitor. Use the AC adapter
kit K-AC117 (optional) or use a battery with ample capacity remaining.
OK
OK
Pixel Mapping
Checks the image sensor
and corrects defective
pixels
Pixel Mapping
Cancel