Sony 300PF ユーザーズマニュアル
Chapter 2 Fitting and Connections
40
Chapter 2
Fitting and Connections
Using Accessories
WRR-810A/860A
Input selection switch: Set to LINE.
To audio mixer, etc.
AUDIO IN
CH-1/CH-2
CH-1/CH-2
5
4
1
4
2,3
LINE
MIC
+48V ON
AUDIO IN
CH-1
FRONT
VJ MIC
VJ MIC
WRR
REAR
CH-2
To connect a WRR-810A/860A
Attach the WRR tuner fitting (not supplied) (Part No.
A-8278-057-A) to the rear of the camcorder as shown
in the following figure.
A-8278-057-A) to the rear of the camcorder as shown
in the following figure.
1
Pass a screwdriver through the holes and tighten
the screws .
the screws .
2
Loosen the adjustment screws.
3
Adjust the metal fitting position for a battery
pack to be attached, and tighten the adjustment
screws to fix its position.
pack to be attached, and tighten the adjustment
screws to fix its position.
4
Attach the holder kit (two fittings and four screws,
supplied with the tuner) to the WRR tuner fitting
(one for the upper position and the other for the
lower position).
supplied with the tuner) to the WRR tuner fitting
(one for the upper position and the other for the
lower position).
5
Mount the tuner on the WRR tuner fitting.
For details about the WRR tuner fitting (Part No. A-8278-
057-A), contact your Sony dealer.
057-A), contact your Sony dealer.
Using an external audio system
Connect an audio mixer or other external audio system
component to the AUDIO IN CH-1/CH-2 connector as
shown below.
component to the AUDIO IN CH-1/CH-2 connector as
shown below.
AUDIO IN (CH-1/CH-2) switches: Set to REAR.