VIZIO VBR 120 ユーザーズマニュアル

VIZIO VBR120 User Manual 

40 

www.VIZIO.com 

 

Make sure the power is ON. 

 

Make sure the AC power cord is securely connected to the AC socket. 

 

Plug another electrical device into the power outlet to verify that the outlet is working. 

 

Point the remote directly at the remote sensor on your player. 

 

Remove any obstacles between the remote control and the remote sensor. 

 

Make sure that bright light does not shine on the remote control sensor or that colored 
glass is not in front of the sensor. Bright light and colored glass can interfere with 
signal reception. 

 

Replace dead batteries with new ones. 

 

If you see  , the action you are trying to do is not allowed by your player or the disc. 

 

A built-in safety device may have been activated. Press 

 on the front of your player 

to turn it off, and then turn it on again. If your player still does not turn on, unplug the 
power cord, wait about one minute, plug it in again, and then press 

 on the front of 

your player. 

 

Condensation may have formed inside your player. Turn on your player, remove the 
disc, leave the tray open, and then leave your player on for two to three hours. 

 

Make sure that the disc has the same region code as your player.  

 

Make sure that the disc is not dirty or defective. 

 

The Parental Controls rating may be blocking the disc. Enter the 4-digit password and 
change the parental settings.  

 

Press the input or source button on the TV remote control to select the input source for 
your player. 

 

Make sure that the disc is inserted with the label facing up. 

 

Make sure that the disc is not dirty or defective. 

 

The disc may be blank or not compatible with your player. For a list of compatible 
discs, see “Playable discs.” 

 

Subtitles are not recorded on the disc. 

 

Turn the subtitles on from the main disc menu. 

 

Resume information is lost when you press 

 

or when you open the disc tray. 

 

Most Blu-ray discs do not support the resume feature. 

 

Make sure that the disc is not dirty or defective. 

 

Make sure there are no obstacles blocking the tray. 

 

The disc may be blank or not compatible with your player. For a list of compatible 
discs, see “Playable discs”. 

 Press

, wait five seconds and then press

 again to reset your player. 

 

Clean the disc if it is dirty. 

 Press

, wait five seconds, and then press 

 again to reset your player. 

 Set 

Optical Disc AutoPlay to On.