Hitachi DZ-HS903A ユーザーズマニュアル
73
Va
rious
Rec
Rec
or
di
ng
T
echn
ique
s
ique
s
Flash mode
Selecting a flash mode
Auto
The flash fires only when necessary.
When the flash is needed, “
When the flash is needed, “
”
appears in the LCD monitor when you
press PHOTO/SELECT halfway,
and then the flash fires when you
press PHOTO/SELECT all the way.
press PHOTO/SELECT halfway,
and then the flash fires when you
press PHOTO/SELECT all the way.
On
“
” is displayed in the LCD monitor
all the time. The flash always fires
when you fully press PHOTO/
SELECT
when you fully press PHOTO/
SELECT
.
Off
“
” is always displayed in the LCD
monitor and the flash will not fire.
1
During record pause, press MENU.
2
Select “Camera Functions Setup”
“Flash”
a flash mode
3
Press the confirmation button to
confirm, then MENU to end.
• To check where the flash icon
confirm, then MENU to end.
• To check where the flash icon
appears in the LCD monitor,
see p.42.
see p.42.
• The flash setting is retained in
memory even when the power
is turned off.
is turned off.
• If “Off” or “On” is selected,
and you do not plan to record
with that flash mode all the
time, we recommend you
return the setting to “Auto”
after recording and before
turning off the power.
with that flash mode all the
time, we recommend you
return the setting to “Auto”
after recording and before
turning off the power.
Hints
• There may be cases when the
recorded pictures are out-of-
focus in dark places even if the
flash is used. We recommend
you shine a light on the subject
for recording in dark places.
focus in dark places even if the
flash is used. We recommend
you shine a light on the subject
for recording in dark places.
• “
” flashes in the LCD
monitor while the flash is
recharging and the flash will not
fire.
recharging and the flash will not
fire.
• When recording stills up close,
set “Flash” setting to “Off”. If
the subject is too close, image
smearing may occur.
the subject is too close, image
smearing may occur.
Notes
• When a conversion lens is
attached, the flash cannot be
used. Adjust the “Flash” setting
to “Off”.
used. Adjust the “Flash” setting
to “Off”.
• Although the flash range differs
according to the subject, as a
reference, its range is about 3.2–
8.2 feet (1–2.5 m) in dark places.
reference, its range is about 3.2–
8.2 feet (1–2.5 m) in dark places.
• Although the amount of light
emitted will automatically be
adjusted at time of emission, the
flash may not be sufficiently
adjusted if the distance to the
subject is too distant or too near.
adjusted at time of emission, the
flash may not be sufficiently
adjusted if the distance to the
subject is too distant or too near.
• In bright or backlit conditions, it
may be difficult to derive the full
effect of the flash.
effect of the flash.
DZ-HS903-803-US-Ea_IM_v01d05n02.p.book Page 73 Friday, September 12, 2008 8:22 PM