Sharp BD-HP52U ユーザーズマニュアル

For the advanced setting (the setting of the 
Ethernet connection speeds), press 

a/b to 

select “Yes” or “No”, then press ENTER.

Normally select “No”, then press ENTER.
The Ethernet connection speeds can be set when you 
select “Yes”, then press ENTER.
As automatic detection is made (factory preset 
mode), this setting is not normally necessary. If a 
situation occurs in which the Ethernet connection fails, 
etc., change the setting and confirm if the Ethernet 
connection successfully works.
When the connection speed is set, select “Next”, then 
press ENTER.

Option
Ethernet Connection Speeds

Next

Auto-Detection

10M Half Duplex

100M Half Duplex

10M Full Duplex

100M Full Duplex

For testing the connection to the internet, after 
confirming the settings, press 

a/b to select 

“Test”, then press ENTER.

“Test” is available only when setting to obtain the IP 
address automatically. “Test” cannot be selected if the 
IP address has not been obtained automatically.

Confirm the current setting.

: xxx xxx xxx xxx
: xxx xxx xxx xxx
: xxx xxx xxx xxx
: xxx xxx xxx xxx
: xx:xx:xx:xx:xx:xx

IP Address
Netmask
Gateway
DNS Address
MAC Address

Test

Complete

As a result of the test, if the internet connection fails, 
enter the setup values manually.

Press 

a/b to select “Complete”, then press 

ENTER.

•
•

•

•

•

BD-HP52U_en.indd   43

BD-HP52U_en.indd   43

2009/09/15   11:35:37

2009/09/15   11:35:37