Sharp BD-HP75U ユーザーズマニュアル

Introduction

TO REDUCE THE RISK OF ELECTRIC 

SHOCK, DO NOT REMOVE COVER. NO 

USER-SERVICEABLE PARTS INSIDE. 

REFER SERVICING TO QUALIFIED SERVICE 

PERSONNEL.

This symbol warns the user of 

uninsulated voltage within the unit 

that can cause dangerous electric 

shocks.
This symbol alerts the user that 

there are important operating and 

maintenance instructions in the 

literature accompanying this unit.

USE OF CONTROLS OR ADJUSTMENTS OR 

PERFORMANCE OF PROCEDURES OTHER THAN 

THOSE SPECIFIED HEREIN MAY RESULT IN 

HAZARDOUS RADIATION EXPOSURE.

AS THE LASER BEAM USED IN THIS UNIT IS 

HARMFUL TO THE EYES, DO NOT ATTEMPT TO 

DISASSEMBLE THE CABINET.

REFER SERVICING TO QUALIFIED PERSONNEL 

ONLY.

• This Player is classified as a CLASS 1 LASER 

product.

• The CLASS 1 LASER PRODUCT label is located 

on the rear cover.

• This product contains a low power laser device. To 

ensure continued safety do not remove any cover 

or attempt to gain access to the inside of the 

product. Refer all servicing to qualified personnel.

This equipment has been tested and found 

to comply with the limits for a Class B digital 

device, pursuant to Part 15 of the FCC Rules. 

These limits are designed to provide reasonable 

protection against harmful interference in a 

residential installation. This equipment generates, 

uses and can radiate radio frequency energy 

and, if not installed and used in accordance with 

the instructions, may cause harmful interference 

to radio communications. However, there is no 

guarantee that interference will not occur in a 

particular installation. If this equipment does 

cause harmful interference to radio or television 

reception, which can be determined by turning 

the equipment off and on, the user is encouraged 

to try to correct the interference by one or more 

of the following measures:

–Reorient or relocate the receiving antenna.

–Increase the separation between the equipment 

and receiver.

–Connect the equipment into an outlet on a 

circuit different from that to which the receiver is 

connected.

–Consult the dealer or an experienced radio/TV 

technician for help.