Sharp BDAMS20 ユーザーズマニュアル

Introduction

TO REDUCE THE RISK OF ELECTRIC SHOCK, 

DO NOT REMOVE COVER. NO 

USER-SERVICEABLE PARTS INSIDE. REFER 

SERVICING TO QUALIFIED SERVICE 

PERSONNEL.

This symbol warns the user of 
uninsulated voltage within the unit 
that can cause dangerous electric 
shocks.
This symbol alerts the user that there 
are important operating and 
maintenance instructions in the 
literature accompanying this unit.

USE OF CONTROLS OR ADJUSTMENTS OR 

PERFORMANCE OF PROCEDURES OTHER THAN 

THOSE SPECIFIED HEREIN MAY RESULT IN 

HAZARDOUS RADIATION EXPOSURE.

AS THE LASER BEAM USED IN THIS UNIT IS 

HARMFUL TO THE EYES, DO NOT ATTEMPT TO 

DISASSEMBLE THE CABINET.

REFER SERVICING TO QUALIFIED PERSONNEL 

ONLY.

• This Player is classified as a CLASS 1 LASER 

product.

• The CLASS 1 LASER PRODUCT label is located 

on the rear cover.

• This product contains a low power laser device. To 

ensure continued safety do not remove any cover 

or attempt to gain access to the inside of the 

product. Refer all servicing to qualified personnel.

This equipment has been tested and found to 

comply with the limits for a Class B digital device, 

pursuant to Part 15 of the FCC Rules. These 

limits are designed to provide reasonable 

protection against harmful interference in a 

residential installation. This equipment generates, 

uses and can radiate radio frequency energy and, 

if not installed and used in accordance with the 

instructions, may cause harmful interference to 

radio communications. However, there is no 

guarantee that interference will not occur in a 

particular installation. If this equipment does 

cause harmful interference to radio or television 

reception, which can be determined by turning 

the equipment off and on, the user is encouraged 

to try to correct the interference by one or more 

of the following measures:

–Reorient or relocate the receiving antenna.

–Increase the separation between the equipment 

and receiver.

–Connect the equipment into an outlet on a circuit 

different from that to which the receiver is 

connected.

–Consult the dealer or an experienced radio/TV 

technician for help.