Sharp BD-HP35S ユーザーズマニュアル

The following problems do not always suggest a defect or malfunction of this Player.

Refer to the problems and lists of possible solutions below before calling for service.

The Player power cannot be turned on.

•  Is the power cord firmly plugged into the AC outlet? (Page 

20)

•  When the power cord is plugged into an AC outlet, press and hold B on the Player until “

” appears on the front 

panel display. Then, after the B (On/Standby) indicator is lit, turn on the power. (Page 

61)

•  Press B

 after the B (On/Standby) indicator turns on. (Page 21)

The Player power is turned off.

•  Is “Auto Power Off” set to “Yes”? When “Auto Power Off” is set to “Yes”, the power will be automatically turned off after 

10 continuous minutes of inactivity (no playback). (Page 

43)

The remote control does not work.

•  Use the remote control within its operating range. (Page 

20)

•  Replace the batteries. (Page 

20)

•  Reset the remote control.

 

−

Press and hold 

1 (the number button) first and then ENTER on the remote control together for more than 5 seconds.

Cannot operate the Player.

•  Are you operating the Player within the specified operating temperature range? (Page 

63) 

The Player cannot play a disc.

•  Take out the disc and clean it. (Page 

13)

•  Make sure that the disc is loaded properly (aligned in disc tray and label-side up). (Page 

25)

•  Make sure that region code on the disc matches that of this Player. (Page 

9)

•  Allow any condensation in or near the Player to dry. (Page 

13)

•  Check that the disc is recorded in the compatible TV system (PAL or NTSC).
•  The Player cannot play back video which was not recorded normally. (Page 

10)

•  Proper playback may be impossible due to the state of the disc recording, a scratched, warped or dirty disc, the state of 

the pick-up, or compatibility issues between this Player and the disc being used. (Pages 

10, 13)

•  When the recorded time of a disc is unusually short, playback may not be possible.
•  BD-RE/R discs recorded in a format other than BDMV/BDAV cannot be played back. (Page 

9)

The disc is automatically ejected after closing the disc 

tray.

•  Make sure that the disc is loaded properly (aligned in disc tray and label-side up). (Page 

25)

•  Take out the disc and clean it. (Page 

13)

•  Make sure that the disc is playable. (Page 

9)