OPPO Digital BDP-80 ユーザーズマニュアル

•  In order to prolong the service life of your player, it is recommended to wait at least 30 seconds 

before you turn it on again after switching it off. 

•  Remove disc and turn power off after operation. 

•  Some functions of the player may not be applicable to certain discs. 

•  Some discs with special features may not be fully supported by the player.  This is not a 

malfunction of the unit. 

•  In case of player malfunction, please turn it off, wait for 30 seconds and turn it back on.  If the 

problem still exists, please follow the troubleshooting instructions or contact an OPPO service 
center. 

 

Use this chart to resolve general operational problems.  If there are any problems that you cannot 
resolve, please contact your OPPO service center. 
 

Audio cable is not properly 
connected 

Check audio cable, and then reconnect if necessary. 

10 - 16 

Mute is activated 

Press the MUTE button to cancel the mute. 

Volume is too low 

Press the VOL + button to increase the volume to 100. 

SACD is played and the audio 
connection is coaxial or optical 
digital audio 

This is not supported due to copyright restrictions of 
SACD.  Please use the analog or HDMI audio output. 
Alternatively, you may set SACD Priority to CD mode 
and the player will play the CD layer. 

15, 44 

“SACD Output” is set to “DSD” 
in the SETUP menu and the 
audio connection is 7.1ch, 
5.1ch or stereo analog audio 
output. 

Set "SACD Output" to "PCM", or connect an A/V 
receiver that supports DSD over HDMI. 

51, 54 

No sound 

DVD-Audio is played and the 
audio connection is coaxial or 
optical digital audio 

This is not supported due to copyright restrictions of 
SACD.  Please use the analog or HDMI audio output.  
Alternatively, you may switch to the DVD-Video 
playback mode. 

15, 44 

Video cable is not properly 
connected 

Check video cable; reconnect if necessary. 

10 - 11 

TV input is not correctly 
selected 

Select the input to which the player is connected. 

 

“Pure Audio” mode engaged 

Press the PURE button to cancel this mode. 

Video output resolution is not 
support by the TV 

Select a proper output resolution that is supported by 
your TV. 

Video system is not supported 
by the TV 

When playback is completely stopped, press and hold 
the P/N button or set the correct TV System in the 
Setup Menu. 

29, 47 

No picture 

Component output is in use yet 
“Primary Output” is set to HDMI 

Set the “Primary Output” menu item to “Component” 
and select an appropriate output resolution. 

12, 18, 46 

Video system is not supported 
by the TV 

When playback is completely stopped, press and hold 
the P/N button or set the correct TV System in the 
Setup Menu. 

29, 47 

Saturation set too low 

Check the saturation setting on TV and player. 

Loose or damaged component 
video cables 

If using component output, check that the three cables 
are all properly plugged in and not damaged.  Make 
sure the color of the plugs match the jacks on both 
ends. 

No color 

Incorrect video output port 

If using composite video output, check that the cable is 
not incorrectly plugged into a component video jack.