Olympus E06 ユーザーズマニュアル
EN 11
En
3. How to connect the electronic flash
Connecting the underwater optical fiber cable
To connect the UFL-2 underwater flash (optional) to the Case using an underwater optical fiber cable
(optional), follow the procedures below.
(optional), follow the procedures below.
Setting of the digital camera
1
Set the RC mode of the camera to ON so that the camera's built-in flash is activated.
2
Load the camera in the Case with the camera's built-in flash popped up.
Refer to the UFL-2 instruction manual for the UFL-2 operation.
How to connect the underwater optical fiber
cable
1
Remove the cap of the optical fiber cable
insertion slot.
insertion slot.
2
Put the underwater optical fiber cable plug all the
way into the optical fiber cable insertion slot.
way into the optical fiber cable insertion slot.
CAUTION:
When using a non-Olympus manufacturer's slave-type flash with underwater optical fiber cable, set the
camera's built-in flash to manual.
If the camera's built-in flash ratio is more than 1/64, the camera's built-in flash light may reflect in the lens port
and be taken into the picture.
camera's built-in flash to manual.
If the camera's built-in flash ratio is more than 1/64, the camera's built-in flash light may reflect in the lens port
and be taken into the picture.
PT-E06_EN.Book Page 11 Thursday, February 26, 2009 5:04 PM