Radio Shack 43-3801 ユーザーズマニュアル
13
Operation
outgoing message or recording an incoming message and
resets to answer another call.
resets to answer another call.
Notes:
• If the system’s memory is full, it answers calls after 10
rings. The caller hears “No one is available to take your
call,” the system sounds a beep, and the caller cannot
leave a message. The system cannot record additional
messages until you delete some of the old messages (see
“Deleting Messages” on Page 17).
call,” the system sounds a beep, and the caller cannot
leave a message. The system cannot record additional
messages until you delete some of the old messages (see
“Deleting Messages” on Page 17).
• Many local phone companies use CPC to signal that the
caller has hung up. Your system can recognize a CPC
signal and release the line. If the system records phone
company messages or dial tones, your local phone
company probably does not use CPC.
signal and release the line. If the system records phone
company messages or dial tones, your local phone
company probably does not use CPC.
USING ANNOUNCE-ONLY
Announce-only sets the system to play a message for the caller,
then automatically disconnects without letting the caller leave a
message.
then automatically disconnects without letting the caller leave a
message.
To select announce-only, slide
INCOMING MSG
to
ANN ONLY
.
When the system receives a call, it answers after two rings and
plays the announce-only message, a long beep sounds, then it
monitors the phone line for remote codes received within about
10 seconds.
plays the announce-only message, a long beep sounds, then it
monitors the phone line for remote codes received within about
10 seconds.
You can use the system’s prerecorded announce-only OGM
“No one is available to take your call,” or record your own.
“No one is available to take your call,” or record your own.
43-3801a.fm Page 13 Monday, February 25, 2002 8:56 AM