Lucent Technologies 555-670-111 ユーザーズマニュアル

Issue 1

April 1999

Programming Procedures 

3-4

Basic System Operating Conditions 

3

Use this procedure to reassign the extension used for system programming. This 
extension should not be the same extension as that used for the operator position. 
The system programming position can be reassigned only to one of the first five 
extension jacks on the first MLX module. Only one system programming console 
is allowed per system.

If you are programming on the console, be aware of the following:

■

The console must be connected to the extension currently assigned for 
system programming.

■

As soon as you change the system programming extension, the system 
programming session is terminated. To proceed with system programming, 
you must connect the system programming console to the newly assigned 
extension and enter system programming again.

The telephone used for system programming must be an MLX-20L.

3

System Manager

All

Not required

1, System Planning

First extension jack on the first MLX module (also set 
as an operator position)

Extension number of one of the first five extension 
jacks on the first MLX module

Restart

The session is finished, and the system

System is restarting

restarts. You must enter system 

programming again to continue.