Crimestopper Security Products CS-2004DC ユーザーズマニュアル

 

BLUE WIRE: (-) HOOD/TRUNK TRIGGER 
The Blue wire is used for a grounding hood pin switch, trunk pin or both.  Connect to existing hood and trunk pin 
switches that read ground when open.  If no existing switches are available, install new pin switches if desired. 

 

GREEN WIRE: (-) DOOR TRIGGER 
Connect to Negative type door switches that read ground when a door is opened and 12 volts when all doors are 
closed.  In the case of isolated door triggers, you may need to run additional wires from other doors OR go directly 
to the dome light. 

 

VIOLET WIRE: (+) DOOR TRIGGER 
Connect to Positive type door switches that show +12 Volts when the door is open and Ground when the doors are 
closed. 

 

This is a programmable output wire that can operate two different ways: 

 

1. 

2. 

(DEFAULT Operation) A Remote Auxiliary Output that provides a ½ Second (-) Negative pulse when Button #3 is 
pressed and released to open a power trunk or hatch release.  Connect this wire to terminal 85 of a relay to operate 
AUX device or function.  Connect terminal 86 or the relay to +12 Volts constant.  Connect terminal 87 to 12Volts or 
Ground depending to the type of circuit needed.  Connect Terminal 30 to the AUX device’s activation wire. 
(MAP Operation) Provides a continuous (-) Negative output when in the alarm system is put into VALET PARK MODE.  
This can be used to interrupt accessory wire of the vehicle preventing unauthorized use of the vehicle’s audio or 
entertainment systems when VALET PARK MODE is ON, hence the name “MAP – Mobile Accessory Protection”.  See 
Mobile Accessories Protection Diagram below. 

FM

105.5

wire of mobile accessories such as Audio system

Connect relay as shown to interrupt the power

RADIO, etc.

or Video monitors. The Alarm will disconnect

these accessories when in VALET PARK MODE.

Relay not included