First Alert 1 ユーザーズマニュアル

86(5)81&7,216

 

0 

Empty 

No event scheduled (or schedule is temporarily disabled) 
 

1 

X-10 Device 

Turn an X-10 device, either on or off at begin/end times. (will 
have a start and end time to program) 

(time driven) 

NOTE: SH10A siren cannot be used. 

2 

Latch Key Report 

Send a special pager report (7110000) indicating system not 
yet disarmed. (will have a start/end time to send the report) 
(window driven), (reports only to pager) 
NOTE: Option *49 must be programmed to be 6 or higher. 
 

Make sure unit is armed prior to start of window time. 

 

In addition a secondary phone number must be 
programmed in Option *42. 

 

3 

Automatic Stay Arming 

Will arm the system automatically, and bypass any open 
zones, at a given time. It will send a report to the pager and 
central station, indicating system has been auto armed stay, 
plus all bypass reports. (will have only a start time to send the 
report) 

(time driven)  

NOTES: (1) Prior executing auto stay arming, force bypass 

will be executed - if option *23 was enabled. 

(2) If pager report is required, Option *49 must be 

programmed to be 6 or higher. 

4 

Reminder Announcements 

Will beep three times and then announce custom words 72, 
73 and 74. This will be repeated every minute until a key is 
depressed, or a button type zone does an arm or disarm.

 †

 

NOTE:  Make sure installer programmed custom words 72-74 

at the time of installation. 

 

5 

Alarm Clock 

Will start a trouble tone (beep) on the speaker, which will 
continue until a key is depressed.

 †

 

 

The beeping sounds will be terminated when any key is pressed during a remote phone control session.