Mitsubishi Electronics Q173CPU(N) ユーザーズマニュアル

13 - 4

13 LIMIT SWITCH OUTPUT FUNCTION

13.2 Limit Output Setting Data

Limit output data list are shown below.
Up to 32 points of output devices can be set.
(The following items of No.1 to No.5 are set together as one point.)

No. Item

Setting

range

Fetch

cycle

Refresh

cycle

Remarks

1 Output device

Bit device (X, Y, M, L, B)

—

Operation

cycle

2 Watch

data

Motion control data/
word device (D, W, #, absolute address)
(16-bit integer type/32-bit integer type/
64-bit floating-point type)

ON Value Word device (D, W, #)/constant (K, H)

ON region
setting

OFF Value Word device (D, W, #)/constant (K, H)

Output enable/disable
bit

Bit device (X, Y, M, L, B, F, special relay)/
none (default)

ON : Enable
OFF : Disable
None : Always

enable

5 Forced output bit

Bit device (X, Y, M, L, B, F, special relay)/
none (default)

Operation

cycle

—

None : No forced

outputs are
always made
(OFF status)

(1) Output device

(a) Set the bit device which outputs the ON/OFF signal toward the preset watch

data.

(b) As the output device, the following devices can be used.

Item

Device No. setting range

Input relay

(Note-1)

X0 to X1FFF

Output relay

(Note-2)

Y0 to Y1FFF

Internal relay

(Note-3)

M0 to M8191

Latch relay

L0 to L8191

Link relay

B0 to B1FFF

(Note-1) : PX is write-disabled and it cannot be used as the output device.

For X, only the free No. of the input card non-loading can be used.

(Note-2) : The real output device range (PY) is also included.
(Note-3) : M2001 to M2032 cannot be used to the output device.

Be careful because it affect a positioning operation, when the positioning
dedicated devices are set.