Magellan MG-6060 ユーザーズマニュアル
Paradox Magellan Systems
19
Figure 20: Remote Control Button Options
* = Hexa values A to F are keys [1] to [6] from Magellan’s Center
Keypad.
Keypad.
†
= The panic feature (section [091] options [1] to [3]; see
page 23) must be enabled in order for this to work.
Figure 21: Replacing the Remote Control’s Battery
Hexa
Value
Description
Hexa
Value
Description
0
Button disabled
8
Panic 1
†
1
Regular arming
9
Panic 2
†
2
Stay arming
A*
Panic 3
†
3
Instant arming
B*
PGM Activation (Event Group #07 - Refer to the Magellan Programming Guide)
4
Force arming
C*
PGM Activation (Event Group #08 - Refer to the Magellan Programming Guide)
5
Future use
D*
Turn FM radio ON/OFF
6
Future use
E*
FM radio memory scan
7
Future use
F*
Paramedic alarm
Inset 1: Removing the Battery
Inset 2: Inserting the New Battery
Step 1
Step 2
WARNING!
Damage to the metal prongs may
occur if the battery is not inserted
correctly.
Damage to the metal prongs may
occur if the battery is not inserted
correctly.
Battery type: One 3V lithium battery (CR2032)
How to replace the battery:
1. Remove the two screws from the back of the remote control and remove the back cover.
2. Slide a teflon screwdriver, or any plastic device, under the battery to remove it from the battery compartment (see Inset 1 below).
2. Slide a teflon screwdriver, or any plastic device, under the battery to remove it from the battery compartment (see Inset 1 below).
Avoid using metal as it may cause a short in the board.
3. Insert the new battery as shown in Inset 2 below. The negative side of the battery is inserted face down.
4. Set the back cover in place and fasten it with the two screws.
4. Set the back cover in place and fasten it with the two screws.