X10 Wireless Technology VK45A ユーザーズマニュアル

If a DSS Receiver or other A/V
component is connected to the TV using
A/V cables, you can connect the Video
Receiver to the free LINE IN jacks on
the component. If there are no LINE IN
jacks, you will need to use a TV
antenna splitter as described earlier.

1. Connect a set of Audio/Video cables

to the A/V OUT jacks of your Video
Receiver. Connect the other end to
your TV.

2. Plug the Video Receiver's Power

Supply (the larger of the two power
supplies) into a 120 volt wall outlet
and plug its jack into the Video
Receiver.

3. Turn the Video Receiver's power switch (on side of unit) on.

4. Set the channel switch to the same letter as you set on the

camera, A, B, C, or D.

5. Position the Video Receiver in a convenient location such as on

top of the TV and orient the antenna so that the flat side points in
the direction of the room where you set up the Video Sender.

You can use the supplied coaxial cable to connect the TV OUT socket
on the Video Receiver to the Antenna input on your TV. If you already
have an antenna connected
to your TV, you will need to
use a TV antenna splitter.

Set your TV and the TV
Channel switch on the
Video Receiver (on bottom)
to the same channel (3 or
4).