Bosch D9112B ユーザーズマニュアル

D9112B | Program Entry Guide | 3.0  User Interface 

EN | 55 

 

 

Bosch Security Systems | 2/04 | 74-06145-000-D 

 

Default: 

P 

Selection: 

Blank, E, or P 

Send Report [COMMAND] [4] [1] and 
[COMMAND] [4] [2]: 

Test the communications link between the panel and 
the central station receiver(s). It can send a 

Test

 

report or a 

Status

 report to the phone numbers as 

programmed in Phone Routing. The 

Test

 report 

includes additional information if 

Expand Tst Rpt

 is 

enabled in the Phone section. 

0101
0101
0101

 

 

Test/Stat Rpt in Phone Routing must be 
programmed with a primary destination. If no 
routing is programmed for the report, the 
command center displays 

SENDING 

REPORT

 but the confirming message 

REPORT SENT

 never displays. 

This is a 

panel-wide function that can be executed 

from any command center assigned to an area where 
the user has authority. 

See Command Center Function Selections in the 
introduction to the Command Center Functions 
programming module for descriptions of selections. 

Default: 

See 

Program Record Sheet

 

Selection: 

Blank or E 

Send Report: See Authority Level Selections in the 
introduction to the Authority Lvl Assign programming 
module for descriptions of selections. 

Default: 

E 

Selection: 

Blank, E, or P 

Change Display [COMMAND] [4] [9]: 

This command center function affects only the 
command center address where the function is 
entered. The user can select either a bright or dim 
display with loud or soft command center warning 
tones, 

Chg Display

 also turns on the continuous 

time and date display. (The time and date display 
clears when a higher priority message needs to be 
displayed.) 

See Command Center Function Selections in the 
introduction to the Command Center Functions 
programming module for descriptions of selections. 

Default: 

See 

Program Record Sheet

 

Selection: 

Blank or E 

Change Display: See Authority Level Selections in the 
introduction to the Authority Lvl Assign programming 
module for descriptions of selections. 

Default: 

E 

Selection: 

Blank, E, or P 

Change Time and Date [COMMAND] [4] [5]: 

Set the time and date in the panel. This is a 

panel-

wide function that can be executed from any 
command center with the scope to view an area 
where the user has authority to perform this 
function. 

See Command Center Function Selections in the 
introduction to the Command Center Functions 
programming module for descriptions of selections. 

Default: 

See 

Program Record Sheet

 

Selection: 

Blank or E 

Change Time and Date: See Authority Level 
Selections in the introduction to the Authority Lvl 
Assign programming module for descriptions of 
selections. 

Default: 

P 

Selection: 

Blank or P 

Change Passcodes [COMMAND] [55]: 

Change the passcode numbers for users already 
programmed into the panel. This is a 

panel-wide 

function that can be executed from any command 
center assigned to an area where the user has 
authority. 

If you enter 

E, the panel treats the entry as P. 

See Command Center Function Selections in the 
introduction to the Command Center Functions 
programming module for descriptions of selections.