Desa GWN10T ユーザーズマニュアル
107902-01D
7
7
For more information, visit www.desatech.com
For more information, visit www.desatech.com
INSTALLATION
Installation Items
Locating Heater
Installing Heater To Wall
INSTALLATION
Continued
Figure 5 - Mounting Screw Locations
Mounting
Screw
Locations
8
7
/
8
"
Blue Flame
10
7
/
8
" Plaque
Minimum To
Maintain 6"
Clearance
From Wall
From Wall
7
3
/
4
"
20
1
/
4
"
Minimum To
Maintain 3"
Clearance
From Floor
FLOOR
JOINING WALL
INSTALLING HEATER TO WALL
Marking Screw Locations
1.
Determine where you will locate heater.
WARNING: Maintain minimum clearances shown
in Figure 5. If you can, provide greater clearances
from floor and joining wall.
from floor and joining wall.
2.
Mark two mounting screw locations on wall (see Figure 5).
Installing Two Mounting Screws
Note:
Wall anchors and mounting screws are in hardware package.
The hardware package is provided with heater.
Attaching to wall stud method
For attaching mounting screw to wall stud
1.
Drill hole at marked location using 9/64" drill bit.
2.
Insert mounting screw into wall stud.
3.
Tighten screw until 1/16" space (thickness of penny) is be-
tween screwhead and wall.
tween screwhead and wall.
Attaching to wall anchor method
Follow instructions below to attach mounting screws to hollow walls
(wall areas between studs) or solid walls (concrete or masonry).
(wall areas between studs) or solid walls (concrete or masonry).
1.
Drill holes at marked locations using 5/16" drill bit. For solid
walls (concrete or masonry), drill at least 1
walls (concrete or masonry), drill at least 1
1
/
4
" deep.
2.
Fold wall anchor (see Figure 6).
Figure 6 - Folding Anchor
Thin Walls (1/4" to 1/2" thick)
Figure 7 - Popping Open Anchor
Wings For Thin Walls
Wings For Thin Walls
Figure 8 - Tightening Anchors
Thin or
Thick Wall
(thick wall
shown)
Thick Wall
(thick wall
shown)
Solid
Wall
Wall
1/16"
Space
Space
Placing Heater On Mounting Screws
1.
Locate two keyhole slots on back panel of heater (see Figure 9).
2.
Place large openings of slots over screwheads. Slide heater
down until screws are in small portion of slots.
down until screws are in small portion of slots.
Figure 9 - Location Of Keyhole Slots On Back Panel Of Heater
Keyhole Slots
3.
Insert wall anchor (wings first) into hole. Tap anchor flush to
wall.
wall.
4.
For thin walls (1/2" or less), insert red key into wall anchor.
Push red key to “pop” open anchor wings (see Figure 7).
Push red key to “pop” open anchor wings (see Figure 7).
IMPORTANT:
Do not hammer key! For thick walls (over 1/2"
thick) or solid walls, do not pop open wings.
5.
Tighten two screws until 1/16" space (thickness of penny) is
between screwheads and wall (see Figure 8).
between screwheads and wall (see Figure 8).