Intel DG43RK LGA-775 socket DDR3 1333/1066 MHz 8GB BOXDG43RK ユーザーズマニュアル

製品コード
BOXDG43RK
ページ / 92
Intel Desktop Board DG43RK Technical Product Specification 
24 
 
1.6.3.2 
SATA Interfaces 
The Intel ICH10 SATA controller offers four independent SATA ports with a theoretical 
maximum transfer rate of 3.0 Gb/s on each port.  One device can be installed on each 
port for a maximum of four SATA devices.  A point-to-point interface is used for host 
to device connections, unlike PATA which supports a master/slave configuration and 
two devices on each channel.   
For compatibility, the underlying SATA functionality is transparent to the operating 
system.  The SATA controller supports IDE and AHCI (Microsoft Windows Vista only) 
configuration and can operate in both legacy and native modes.  In legacy mode, 
standard ATA I/O and IRQ resources are assigned (IRQ 14 and 15).  In Native mode, 
standard Conventional PCI bus resource steering is used.  Native mode is the 
preferred mode for configurations using the Windows* XP and Windows Vista 
operating systems.   
 
 
For information about  
Refer to 
Obtaining AHCI driver 
Section 1.3, page 14 
The location of the SATA connectors 
 
1.7 
Real-Time Clock Subsystem 
A coin-cell battery (CR2032) powers the real-time clock and CMOS memory.  When 
the computer is not plugged into a wall socket, the battery has an estimated life of 
three years.  When the computer is plugged in, the standby current from the power 
supply extends the life of the battery.  The clock is accurate to ± 13 minutes/year at 
25 ºC with 3.3 VSB applied. 
 
NOTE 
If the battery and AC power fail, custom defaults, if previously saved, will be loaded 
into CMOS RAM at power-on.  
 
When the voltage drops below a certain level, the BIOS Setup program settings stored 
in CMOS RAM (for example, the date and time) might not be accurate.  Replace the 
battery with an equivalent one.  Figure 1 on page 11 shows the location of the battery.