Therma-Tru Light Commercial Doors and Frames ユーザーズマニュアル
Therma-Tru
®
Light Commercial/Multi-Family - Doors and Frames
• Material shown on these drawings will be
fabricated only after formal approval by the
architect, receipt of approval hardware schedule,
and all necessary hardware templates.
fabricated only after formal approval by the
architect, receipt of approval hardware schedule,
and all necessary hardware templates.
• All frames shall be shipped “knocked-down”
unless otherwise specified.
unless otherwise specified.
• All frames and doors shall be chemically washed,
rinsed, and dried prior to receiving one coat of
paint.
rinsed, and dried prior to receiving one coat of
paint.
• Doors and frames will be reinforced for surface
mounted hardware as required. Drilling and
tapping for surface mounted hardware shall be
applied by others.
mounted hardware as required. Drilling and
tapping for surface mounted hardware shall be
applied by others.
• It will be the responsibility of the General
Contractor to coordinate hardware locations.
Contractor to coordinate hardware locations.
• All frames will be supplied with the required wall
and floor anchors as illustrated on the frame detail
sheet.
and floor anchors as illustrated on the frame detail
sheet.
• All frames and doors wll be tagged with shop
marks. This schedule can be used to cross
reference shop marks with architects marks.
marks. This schedule can be used to cross
reference shop marks with architects marks.
• These drawings are not intended for use by other
trades.
trades.
• Field welding, grinding, finishing, and attachment
of field splices by others.
of field splices by others.
DOOR HANDING CHART
• All standard type hardware will be located at this
manufacturer’s standard locations as shown on
the door and frame elevations. Hardware items
such as panic exit devices, deadbolts, etc. will also
be located at manufacturer’s standard locations
unless specifically advised.
manufacturer’s standard locations as shown on
the door and frame elevations. Hardware items
such as panic exit devices, deadbolts, etc. will also
be located at manufacturer’s standard locations
unless specifically advised.
• Installations of all glass and glazing to be
performed by others.
performed by others.
• Doors, frames, and finished hardware to be
installed by others.
installed by others.
• Anchor bolts and expansion shields for any type
fastener to be furnished by others.
fastener to be furnished by others.
• All frames must be set absolutely plumb, square,
and level.
and level.
• All frames will be supplied with rubber door
silencers: three for single swing openings and two
per header for double swing openings.
silencers: three for single swing openings and two
per header for double swing openings.
SHEET NUMBER:
OF
JOB NUMBER:
ARCHITECT:
LOCATION:
PROJECT:
FINISHED HARDWARE BY:
CONTRACTOR:
RECORD OF SUBMITTALS
SUBMITTED
RETURNED
1st
2nd
3rd
4th
RECORDED APPROVED DRAWINGS
DRAWN BY:
RECORDED APPROVED HARDWARE
G
EN
ER
A
L
N
O
T
ES
OUTSIDE
LEFT HAND INSWING
OUTSIDE
RIGHT HAND INSWING
OUTSIDE
LEFT HAND REVERSE
OUTSIDE
RIGHT HAND REVERSE
SINGLE DOORS
RIGHT HAND REVERSE/
LEFT HAND OUTSWING
LEFT HAND REVERSE/
RIGHT HAND OUTSWING
SINGLE DOORS
OUTSIDE
OUTSIDE
OUTSIDE
OUTSIDE
LEFT HAND ACTIVE
RIGHT HAND ACTIVE
LEFT HAND REVERSE ACTIVE
RIGHT HAND REVERSE ACTIVE
PAIRS OF DOORS
LEFT HAND REVERSE ACTIVE/
RIGHT HAND OUTSWING ACTIVE
OUTSIDE
OUTSIDE
OUTSIDE
OUTSIDE
LEFT HAND ACTIVE
RIGHT HAND ACTIVE
LEFT HAND REVERSE ACTIVE
RIGHT HAND REVERSE ACTIVE
PAIRS OF DOORS
RIGHT HAND REVERSE ACTIVE/
LEFT HAND OUTSWING ACTIVE
PAIRS OF DOORS