Paradox Hellas S.A. EVO96 ユーザーズマニュアル

When your system is disarmed, it deactivates any alarms in progress, and it deactivates the zones so the alarm will not be 
triggered if zones are breached.

Your installer will program designated entry points (i.e. the front door) with an Entry Delay 
Timer. This delay gives you time to enter the armed premises and enter your code to 
disarm your system before the alarm is triggered. 

You can only disarm an area to which your user access code is assigned. User access 
codes with the “Arm Only” (section 6.7 on page 14) option enabled cannot disarm an 
armed system.

How do I disarm the system?

1. Enter your [

]. 

2. Press the [

] button or the [

] key. If you have access to more than one area, 

select the area(s) you wish to disarm (refer to section 5.2 on page 9).

To disarm a system in alarm:

1. Enter your [

]. 

2. In the case of a false alarm, call your monitoring station quickly to advise them of the 

false alarm.

Your system will record all the alarms that occurred during the last armed period. The 
zones in alarm will remain in the Alarm Memory until the next time that area is armed.

How do I view the list of alarms that occurred?

1. When an alarm has occurred, the DGP2-641BL/RB keypad’s screen will display 

Alarms in Memory [mem] to View, the Memory   icon or  the 

 action 

light will illuminate. 

2. Press the [

] button or the [

] key. The Memory 

 icon will flash. 

Each zone that was breached while armed will appear below 

Alarm in:.

Zone icons on the left side of the screen will illuminate to display zones that caused an 
alarm. 

The 

 action light will flash and the numerical light(s) for each zone whose alarm 

was triggered will illuminate.

3. Press the [

] button to exit the Alarm Memory Display.