Monte Carlo Fan Company 5SWR54XXD Series ユーザーズマニュアル

Raise fan with downrod assembled to

the ceiling bracket and hang fan

assembly. Be sure to rotate the

downrod ball so that the notch in the

bracket engages the slot in the ball.

Install outer upper glass to fan body.

Install 4 x 25 watt candelabra base

bulbs.

Install downrod into yoke. Align hole

in downrod with hole in yoke and

install cross pin. Install keeper into

cross pin.

Tighten 2 downrod set screws and

lock nuts.

Set dip switches on the Remote Transmitter and Remote

Receiver to the same settings.  This must be done so the

units will communcate properly.  If you have other fans you

can set to control from one transmitter by setting both

receivers the same as the transmitter.  If you have more

than one fan with remote.  You can set the dip switches to

different positiosns to have seperate control.

Remote Transmitter Dip swtiches

Remote Receiver Dip switches

Fan and light kit combinations over 35 lbs,

in both flush and downrod mode the safety

cable must be installed into the house struc-

ture beams using the 3” lag screws,washers,

and lock washers. provided.  Make sure that

when the safety cable is fully extended the

lead wires are longer than the cable and no

stress is placed on the lead wires. 

Safety cable installation

safety

cable

3” lag

screw

lock

washer

washer

Install inner upper glass to fan body.

Install canopy onto downrod.

Install half ball on downrod and slide

pin into hole in downrod. Then raise

half ball so that pin fits in notches in

half ball.

Tighen set screw in half ball.

Thread lead wires and safety cable

through downrod as shown.