Monte Carlo Fan Company 5YM52 ユーザーズマニュアル

Tighen 2 downrod set screws and then

tighen lock nuts.

Align hole in downrod with hole in

yoke and install cross pin.

Install keeper pin into cross pin.

Loosen 2 screws and remove pin

with keeper for downrod, yoke cover,

and canopy to fit in yoke of fan.

Install downrod into yoke.

Thread black wire, white wire, blue

wire and safety cable through down-

rod.

Lift mounting neck to mounting Plate

and align screws. 

Secure mounting neck to the mount-

ing plate with four screws to become

a complete mounting bracket.

For Canadian installation in both flush and

downrod mode the safety cable must be

installed into the house structure beams using

the 3” lag screws provided.  Make sure that

when the safety cable is fully extended the

leadwires are longer than the cable and no

stress is placed on the leadwires.

Canadian mounting only

Make wire connections to power source using

wire nuts provided.  Make sure that no filiments

are outside of the wirenut. After making the

wire connections, the wires should be spread

apart with the grounded conductor and the

equipment-grounding conductor on one side of

the outlet box and ungrounded conductor on

the other side of the outlet box.

Re-install safety bar removed in

step. 3 by placing safety bar on

screws, sliding into place, and tight-

ening the 2 screws.

For pul chain controls, follow diagram above.

Make sure that all exposed wiring is secured

inside wire nuts. Note: Wires from house may

vary in color and may not include ground wire.

After wiring is complete, gently push wires into

junction box with wire nuts pointing upward.

Refer to point 3 of safety tips.

House

Fan

Black

White

Green

Black

White

Green(downrod)

Green(Bracket)

Blue