Monte Carlo Fan Company 5STR52 ユーザーズマニュアル

Loosen the 3 screws with slots and remove the other

3 screws. Save the screws.

Take the last allen screw and align with hole in

the switch housing cap or light kit, then tighten

all 3 allen screws securely.

To remove the top motor cover twist the cover

and remove this will allow acesss to the screw

holes for the blade arms.

Place blade arm over label on the fan body and

tighten the 2 screws in the blade arm to the

fan body. 

Place medallion in blade for long blade arm.

Repeat for each blade.   

When attaching the second blade and arm to

fan it should go under the first blade as shown

in photo. Repeat for the other blades and arms.

Attach long blade arm to medallion with 2

screws, only start screws.  Repeat for each long

blade arm. 

Attach the long blade arms to motor after attach-

ing to blade. Tighten screws to motor securely

and repeat for each blade arm. Caution go back

and securely tighen screws in step 15.  

Thread wires and safety cable through motor cover.  

Place motor cover over 3 screws and twist

cover into position. Take 3 screws removed ear-

lier and replace, tighten all 6 screws securely.

Place medallion on side of blade  not marked

this side up.  Flip the blade over and attach

short arm to set of holes that are closest to the

corner of the blade.  The remaining set of holes

is for the long arm. Repeat for each blade.

Use this label on the fan body for the first blade arm

starting position. Use caution with blade arms and

Label