Monte Carlo Fan Company 8ATR44 ユーザーズマニュアル

Carefully lift fan assembly onto mounting brack-

et. Rotate fan so that the notch on the ball

engages the ridge in the mounting bracket. This

will allow hands-free wiring. 

Make wire connections to power source using

wire nuts provided.  Make sure that no filiments

are outside of the wirenut. After making the

wire connections, the wires should be spread

apart with the grounded conductor and the

equipment-grounding conductor on one side of

the outlet box and ungrounded conductor on

the other side of the outlet box.

For Canadian installation and for USA fan and

light kit combinations over 35 lbs, in both flush

and downrod mode the safety cable must be

installed into the house structure beams using

the 3” lag screws provided.  Make sure that

when the safety cable is fully extended the

leadwires are longer than the cable and no

stress is placed on the leadwires.

Safety cable installation

Raise the canopy up and align the

two holes in the canopy with the two

holes in the hanger bracket. Secure

with two  screws provided.

Tighten both yoke set screws and

lock nuts to further secure downrod. 

Install upper glass over downrod

onto fan body.

Install canopy over downrod.

Caution: Replace pin and ball onto

downrod. 

Tighen set screw loosened in step 5.

Set dip switches on the Remote Transmitter and Remote

Receiver to the same settings.  This must be done so the

units will communcate properly.  If you have other fans you

can set to control from one transmitter by setting both

receivers the same as the transmitter.  If you have more

than one fan with remote.  You can set the dip switches to

different positiosns to have seperate control.

Remote Transmitter Dip swtiches

Remote Receiver Dip switches

Install remote receiver by sliding into opening

in the mounting bracket. Make sure that the dip

switches on the transmitter and the receiver are

set to the same positions.

white

Black

Make wiring connections as indicated above.

White from fan to white from remote marked

N.  Orange from fan to Orange from remote

marked Light/up. Blue from fan to blue from

remote marked down light. Black from fan to

Black from remote marked L.  White from

house to white from remote marked AC N .

Black from house to Black from remote

marked AC  L. Connect all green ground wires

to Ground wire from House.

orange

blue

Green

white
black

House

Fan

Install 1 x 100 watt Edison base

bulb.