Monte Carlo Fan Company 5RDR ユーザーズマニュアル

Install decorative cap.

Hang assembled fan from the mounting brack-

et. Make sure the fan is hanging straight.

Rotate fan until the tab on the Mounting bracket

engages the slot on the Downrod Ball.  This

must be done to prevent the fan body from

rotating when the blades are in motion.

Rotate slide on mounting bracket till it stops so

the screw holes will align for 2 canopy screws

in hardware pack. Tighten the 2 screws secure-

ly. These will lock slide in place till ready to

mount canopy. (step 34) 

Tighen the 3 screws holding the arch

arms securely.

Set dip switches on the Remote Transmitter and Remote

Receiver to the same settings.  This must be done so the

units will communcate properly.  If you have other fans you

can set to control from one transmitter by setting both

receivers the same as the transmitter.  If you have more than

one fan with remote.  You can set the dip switches to differ-

ent positiosns to have seperate control.

Remote Transmitter Dip swtiches

Remote Receiver Dip switches

Thread leadwires and safety cable

through the canopy. Place canopy

over the downrod.

Push the yoke cover down into

place.

Install arch mount by using screw

and nut removed in step 16. Place

screw through tab and tighten nut

and screw securely.

Align holes in arch arm and slot for

tab with holes and tab on fan body.

Start all screws in the arch arm

brackets.

Plug in electrical connections there

are 2 double plugs from arch assem-

bly one for the fan and one for the

up and down lights.

Install  6 x 15 watt candelabra tor-

pedo shape bulbs.

Tighen all 6 screws for arch arms

securely.