Monte Carlo Fan Company 5GL66 Series ユーザーズマニュアル

Insert downrod into yoke. Align hole

in the downrod with the hole in the

yoke. Insert cross pin through yoke

and downrod. Insert cotter pin in to

cross pin to secure.

Tighten yoke set screws securely and

evenly.

Loosen the 2 set screws in yoke for

downrod to slip into yoke.

Remove keeper from pin and then

remove pin. Replace keeper in pin

and save.

Place canopy and yoke cover on

downrod. Thread leadwires through

the downrod.

Make wire connections to power source using

wire nuts provided.  Make sure that no filiments

are outside of the wirenut. After making the

wire connections, the wires should be spread

apart with the grounded conductor and the

equipment-grounding conductor on one side of

the outlet box and ungrounded conductor on

the other side of the outlet box.

Hang assembled fan from the mounting bracket

installed to ceiling in previous step.  Make sure

the fan is hanging straight.  Rotate fan until the

tab on the Mounting bracket engages the slot

on the Downrod Ball.  This must be done to

prevent the fan body from rotating when the

blades are in motion.

Re-install safety bar removed in

step. 3 by placing safety bar on

screws, sliding into place, and tight-

ening the 2 screws.

Lift mounting neck to mounting Plate

and align screws. 

Secure mounting neck to the mount-

ing plate with four screws to become

a complete mounting bracket.

Fan and light kit combinations over 35 lbs,

in both flush and downrod mode the safety

cable must be installed into the house struc-

ture beams using the 3” lag screws,washers,

and lock washers. provided.  Make sure that

when the safety cable is fully extended the

lead wires are longer than the cable and no

stress is placed on the lead wires. 

Safety cable installation

safety

cable

3” lag

screw

lock

washer

washer

For pullchain controls, follow diagram above.

Make sure that all exposed wiring is secured

inside wire nuts. Note: Wires from house may

vary in color and may not include ground wire.

After wiring is complete, gently push wires into

junction box with wire nuts pointing upward.

Refer to point 3 of safety tips.

House

Fan

Black

White

Green

Black

White

Green(downrod)

Green(Bracket)

Blue