Monte Carlo Fan Company 5EG60XX Series ユーザーズマニュアル

Remove 4 screws around light plate.

Save screws.  

Loosen 2 screws and remove 1 screw

from motor plate and save screw. 

Snap plastic covers in place to cover

screws.

Replace 1 screw removed and tighten

the 4 screws securely.

Carefully lift fan to loosened screws

on mounting plate and twist clock-

wise till tight.. 

Install 3 screws and washers per

blade and tighten securely. Repeat

for all 5  blades

Check the motor for shipping stabilizers and

remove if present. The screws, washers, and

motor pads are pre-installed to the blade

holders. Attach blade assembly to motor and

tighten screws securely.

Install light pan by twisting pan with

key hole slots into place. Replace

screw removed and tighten the 3

screws securely.  

Make wire connections to power source using wire nuts
provided.  Make sure that no filiments are outside of
the wirenut. After making the wire connections, the
wires should be spread apart with the grounded con-
ductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on
the other side of the outlet box.  

Connect black and blue wire from fan to Black or (Hot)

wire from house.  Connect White wire from Fan to

White (Neutral) wire from house.  Connect Ground

leads from mounting bracket and downrod to Ground

lead from house.  Refer to Safety Tips section of

Blue 

Black

White

Green

Black

White

Ground

Hang fan from hook on the mounting

plate. Use the closed hole. This will

allow for hands free wiring.

For control of fan and optional light from wall

location, follow diagram above. NOTE: A profes-

sional electrician is recommended for this type

of installation.