Monte Carlo Fan Company 5AHR60 ユーザーズマニュアル

While lifting upward on the arch arm assembly tighten

the 2 set screws next to each cross pin where archs

attach to the fan housing.  These set screws can be

loosened and adjusted once fan is in final position on

the ceiling.

Align hole in arch arm and hole in tab the fan

housing.  Do this for each of the 3 arch arms.

Install Keeper pin into all 3 cross pins.

Install 3 screws to hold glass to fan housing.

Do not overtighten as this could crack the

glass.

Install and tighten set screws for each arch leg

located on the yoke.

Spread 3 arch arms outward and place over the

tabs on fan housing. Make sure the arm with

the electrical connection plugs is next to the

plugs on the fan housing.

Lower upper glass disk onto fan housing and

align 3 holes in glass with 3 holes in fan hous-

ing.

Lift mounting neck to mounting Plate and align

screws. 

Secure mounting neck to the mounting plate

with four screws to become a complete mount-

ing bracket.

Loosen the 2 downrod set screws to allow

downrod intallation to the yoke.

Plug in electrical connection from Arch assembly

to the fan body.

Install canopy and yoke cover over the down-

rod.