Monte Carlo Fan Company 5KBR54 ユーザーズマニュアル

install cotter pin into cross pin.

Install downrod into yoke.

Install 4 x 40 watt candelabra base bulbs

included. 

Raise fan with downrod assembled to the ceil-

ing bracket and hang fan assembly.  Be sure to

rotate the downrod ball so that the notch in the

bracket engages the slot in the ball.

For Canadian installation in both flush and

downrod mode the safety cable must be

installed into the house structure beams using

the 3” lag screws provided.  Make sure that

when the safety cable is fully extended the

leadwires are longer than the cable and no

stress is placed on the leadwires.

Loosen 2 screws and remove pin with keeper

for downrod, yoke cover and canopy to fit in

yoke of fan.

Install canopy and yoke cover onto downrod as

shown. Thread wires and safety cable through

downrod.

Set dip switches on the Remote Transmitter and Remote

Receiver to the same settings.  This must be done so the

units will communcate properly.  If you have other fans you

can set to control from one transmitter by setting both

receivers the same as the transmitter.  If you have more

than one fan with remote.  You can set the dip switches to

different positiosns to have seperate control.

Remote Transmitter Dip swtiches

Remote Receiver Dip switches

Lift mounting neck to mounting Plate and align

screws. 

Secure mounting neck to the mounting plate

with four screws to become a complete mount-

ing bracket.

Tighten 2 downrod set screws and lock nuts.

Align hole in downrod with hole in yoke and

install cross pin.