Monte Carlo Fan Company 5GIR54XXD ユーザーズマニュアル

Raise fan with downrod assembled to

the ceiling bracket and hang fan

assembly. Be sure to rotate the

downrod ball so that the notch in the

bracket engages the slot in the ball.

Align hole in downrod with hole in

yoke and install cross pin. Install

downrod into yoke. Install keeper

into cross pin.

Tighten 2 downrod set screws and

lock nuts.

Set dip switches on the Remote Transmitter and Remote

Receiver to the same settings.  This must be done so the

units will communcate properly.  If you have other fans you

can set to control from one transmitter by setting both

receivers the same as the transmitter.  If you have more

than one fan with remote.  You can set the dip switches to

different positiosns to have seperate control.

Remote Transmitter Dip swtiches

Remote Receiver Dip switches

Install remote receiver by sliding into opening in

the Mounting bracket.  Make sure that the dip

switches on the Transmitter and the Receiver

are set to the same position.  See Fig 38 for

remote operation

Fan and light kit combinations over 35 lbs,

in both flush and downrod mode the safety

cable must be installed into the house struc-

ture beams using the 3” lag screws,washers,

and lock washers. provided.  Make sure that

when the safety cable is fully extended the

lead wires are longer than the cable and no

stress is placed on the lead wires. 

Safety cable installation

safety

cable

3” lag

screw

lock

washer

washer

Remove all 4 screws from Mounting

bracket.  These screws will not be

needed for Downrod Mode installa-

tion

Make sure the studs protruding from

the bottom of the Mounting bracket

are installed with threads all the way

through the bracket.  

Make wiring connections as indicated above.

White from fan to white from remote marked

N. Blue from fan to blue from remote marked

light. Black from fan to Black from remote

marked L. White from house to white from

remote marked AC N . Black from house to

Black from remote marked AC L. Connect all

green ground wires to Ground wire from

House.

white

black

Make wire connections to power source using

wire nuts provided.  Make sure that no filiments

are outside of the wirenut. After making the

wire connections, the wires should be spread

apart with the grounded conductor and the

equipment-grounding conductor on one side of

the outlet box and ungrounded conductor on

the other side of the outlet box.

Next lift the cover ring and install knurled

nuts as shown.  Tighten the knurled nuts

securely.  The canopy should adjust for

any irregularity in the ceiling or Outlet

box.

Pass leadwires  and safety cable through

the canopy.

FFlluusshh M

Moouunntt IInnssttaallllaattiioonn