Hunter Fan 42606-01 ユーザーズマニュアル

Hunter Fan Company 

42606-01 • 11/18/05 

42606-01 • 11/18/05 

Hunter Fan Company

Low Profile 

Washer

Downrod 

Canopy

Set Screw

Locking Screw

 

 WARNING:  Fan may fall if not assembled as directed in these 

installation instructions.

3-1.  Unbundle the wires from the fan.
For Standard or Angle mounting:
3-2.  Insert the downrod through the canopy and canopy trim ring. 

Feed the wires from the fan through the downrod on one side of 
the pin in the ball. 

3-3.  Loosen the square head set screw on the adapter to install the 

pipe and ball assembly. Note: When the pipe and ball assembly 
is fully installed, 2-3 threads on the pipe will still be visible; this is 
normal. Securely retighten the set screw with a wrench or pliers. 
Go to 4 • Hanging and Wiring the Fan.

     

 CAUTION: e adapter has a special coating on the threads. Do 

not remove this coating; the coating prevents the downrod from 
unscrewing. Once assembled, do not remove the downrod.

For Low Profile mounting:
    Note: For low profile mounting, the downrod is replaced with the 

low profile washer. 

3-4.  Remove the set screw from the adapter.
3-5.  Place the low profile washer into the canopy with the lip down.
3-6.  Align the holes in the washer with the holes in the adapter. 

Assemble securely with three locking screws. Go to 4 • Hanging 
and Wiring the Fan.

Canopy 

Trim Ring

Green 

Ground 

Wire

Locking Screws

Canopy

Canopy 

Trim Ring

Adapter

Low Profile 

Washer

Locking Screws