Rinnai FS35ETRSN/US ユーザーズマニュアル
7
TECHNICAL SPECIFICATIONS
COMPARTMENTS, BURNERS AND
CIRCULATING AIR PASSAGEWAYS
OF THE APPLIANCE ARE KEPT
CLEAN.
CIRCULATING AIR PASSAGEWAYS
OF THE APPLIANCE ARE KEPT
CLEAN.
35 The glass window shall be replaced as
one piece as supplied by the
manufacturer. See log and glass
installation on page 15.
manufacturer. See log and glass
installation on page 15.
36 Do not substitute glass, glowing embers
or logs. Use only glass, glowing embers
and logs supplied by manufacturer.
and logs supplied by manufacturer.
37 Caution: Do not operate unit with broken
glass.
38 WARNING: DO NOT OPERATE
APPLIANCE WITH THE FRONT
REMOVED, CRACKED OR BROKEN.
REPLACEMENT OF THE GLASS
SHOULD BE DONE BY A LICENSED
OR QUALIFIED SERVICE PERSON.
REMOVED, CRACKED OR BROKEN.
REPLACEMENT OF THE GLASS
SHOULD BE DONE BY A LICENSED
OR QUALIFIED SERVICE PERSON.
39 WARNING: Electrical grounding
instructions. This appliance is equipped
with a three prong (grounding) plug for
your protection against shock hazard
and should be plugged directly into a
properly grounded three-prong
receptacle. Do not cut or remove the
grounding prong from this plug.
with a three prong (grounding) plug for
your protection against shock hazard
and should be plugged directly into a
properly grounded three-prong
receptacle. Do not cut or remove the
grounding prong from this plug.
Natural Gas
Propane
Gas Input Rate:
Btu/hr
Btu/hr
Pilot:
200
200
Low:
11,000
9,000
High:
32,000
29,000
WC
WC
Min:
7"
10"
Max:
10.5"
13"
Gas Connection:
Flue Termination:
Fan:
Combustion System:
Ignition System:
Operation:
Temperature control:
Flue Termination:
Fan:
Combustion System:
Ignition System:
Operation:
Temperature control:
Electronic thermostat High~Low / Off
Flame picture select option
Up / Down buttons
Flame picture select option
Up / Down buttons
Temperature range:
Low = 50°F, 60°F~80°F, High 97°F
Safety Devices:
Power surge - 3 amp fuse
Room overheat - Automatic cut off at 104°F after 10 minutes
Room overheat - Automatic cut off at 104°F after 10 minutes
Fan delay
Micro computer timer
Combustion Method:
Flue Type:
Heat transfer:
Installation Type:
Flue Requirement:
Flue Type:
Heat transfer:
Installation Type:
Flue Requirement:
Flame failure- flame rod
Over heat - thermistors, thermal fuse
Over heat - thermistors, thermal fuse
Free standing
Manufacturers minimum, 10 ft vertical.
Manufacturers minimum, 10 ft vertical.
Naturally aspirated burner
Approved 4" B vent system
Direct radiation and forced convection
Approved 4" B vent system
Direct radiation and forced convection
Local codes may have a greater
requirement and must be followed
requirement and must be followed
Minimum permissible
gas supply pressure for
purpose of input
adjustment
gas supply pressure for
purpose of input
adjustment
3/8" FNPT
Finger touch control buttons or remote control
An approved 4" vent cap must be fitted to all installations
90 Watt 2 speed tangential
Multi port burner and ceramic logs
Continuous spark electronic ignition
90 Watt 2 speed tangential
Multi port burner and ceramic logs
Continuous spark electronic ignition