Electrolux W 345 B/M ユーザーズマニュアル

 

Open the tank lid.

Fill the left tank with water to within about 75mm 
(3”) from the top edge then add the scrubbing 
detergent in a quantity to make a dilution 
according to its instruction.

Too strong a mix wastes detergent, too weak a 
mix will not work efficiently.

The machine is now ready for use so move off to 
the site to be cleaned.

Switch the machine on by turning the key in the 
key-switch a quarter turn clockwise.

 

Unclip the recovery tank emptying hose and 
remove the drain plug whilst holding the pipe at 
its highest extent, then lower it carefully into a 
gully or drain.

 

It is against Water Regulations to discharge 
detergents into a surface drain, only use a foul 
gully or drain.

At the same time as emptying the recovery tank 
check if the clean tank requires refilling.
If the clean liquid runs out then it is recommended 
that to save time the recovery tank be emptied at 
the same time as the clean tank is refilled.

A switch is fitted on the rear panel to the right of 
the control handle which controls the drive motor 
power. With the switch lever in the up position the 
traction motor is disconnected and the machine 
may be pushed easily from site to site when the 
mains lead is unplugged or when the batteries are 
not available.