Alen MDF-50AE ユーザーズマニュアル
7
CARE AND MAINTENANCE
Removing the collected water
1. Pull out the bucket a little.
2. Hold both sides of the bucket
with even strength, and pull it
out from the unit.
with even strength, and pull it
out from the unit.
3. Pour the water out.
There are two ways to remove collected water.
1. Use the bucket
When the bucket is full, the unit will automatically stop
running, and the Full indicator light will flash.
Slowly pull out the bucket. Grip the left and right handles
securely, and carefully pull out straight so water does
not spill. Do not put the tank on the floor because the
bottom of the bucket is uneven. Otherwise the bucket
will fall and cause the water to spill.
Throw away the water and replace the bucket. The
bucket must be in place and securely seated for the
dehumidifier to operate.
The machine will re-start when the bucket is restored
in its correct position.
1. Use the bucket
When the bucket is full, the unit will automatically stop
running, and the Full indicator light will flash.
Slowly pull out the bucket. Grip the left and right handles
securely, and carefully pull out straight so water does
not spill. Do not put the tank on the floor because the
bottom of the bucket is uneven. Otherwise the bucket
will fall and cause the water to spill.
Throw away the water and replace the bucket. The
bucket must be in place and securely seated for the
dehumidifier to operate.
The machine will re-start when the bucket is restored
in its correct position.
NOTES:
When you remove the bucket, do not touch any parts
inside of the unit. Doing so may damage the product.
Be sure to push the bucket gently all the way into the
unit. Banging the bucket against anything or failing to
push it in securely may cause the unit not to operate.
When you remove the bucket, do not touch any parts
inside of the unit. Doing so may damage the product.
Be sure to push the bucket gently all the way into the
unit. Banging the bucket against anything or failing to
push it in securely may cause the unit not to operate.
NOTE: When the continuous drain feature is not being
used, remove the drain hose from the connector and
attach the back drain hole with the rubber plug shown
in Fig.1.
used, remove the drain hose from the connector and
attach the back drain hole with the rubber plug shown
in Fig.1.
Remove the water bucket from the front of the unit, you will
find a section of hose located above the bucket.
Remove the rubber plug from the back of the unit and store
it in a safe location(see Fig.8).
Insert the water hose through the hole in the back of the unit
and securely press it onto the connector on the front of the
unit(see Fig.9). Then lead the water hose to the floor drain or
a suitable drainage facility.
unit(see Fig.9). Then lead the water hose to the floor drain or
a suitable drainage facility.
Replace the bucket in the unit. The bucket must be in place and
securely seated.
2. Continuous draining
Water can be automatically emptied into a floor
drain by attaching the unit with a water hose
(not included).
drain by attaching the unit with a water hose
(not included).
Remove the
rubber plug
rubber plug
Push the hose
into the drain
hole
into the drain
hole
Fig.5
Fig.6
Fig.7
Fig.8
Connector
Fig.9
Drain hose