HP (Hewlett-Packard) 20-Feb ユーザーズマニュアル
Chapter 5
Removing and Replacing Drive Modules 163
Ch
apter 5
Removing a Drive Module
Note
To preserve SCSI communications, do not loosen or remove the
SCSI cable(s) connected to the outside of the drive module. The
connection to be removed is located inside the drive module.
Remove the drive module using the steps below:
1. Verify the external SCSI cable is tightened to the connector plate.
2. Loosen the thumbscrews on each side of the connector plate, located in the
1. Verify the external SCSI cable is tightened to the connector plate.
2. Loosen the thumbscrews on each side of the connector plate, located in the
middle of the drive module (
on page 163). If this is your first
time loosening the thumbscrews, use a screwdriver.
3. Gently remove the connector plate, with SCSI cable(s) still connected.
Caution
Use standard precautions for electro-static discharge (ESD)
protection.
4. Grasp the ribbon cable that is plugged into the drive module. Remove the
the location of the ribbon cable and connector.
Figure 51
Ribbon Cable and Connector