AllerAir 600 DX プリント
INSTALLING FILTER ASSEMBLY-
600 D, DX
Step 3
Gently grasp wheels.
Remove base by gently pulling on
the wheels.
Remove base by gently pulling on
the wheels.
Step 1
Turn Power Off and
unplug receptacle.
Lay unit upside down.
unplug receptacle.
Lay unit upside down.
Step 5
Insert the carbon filter (either a
Model 600 D Carbon or a Model 600
DX Carbon) into the unit.
Model 600 D Carbon or a Model 600
DX Carbon) into the unit.
Step 4
Remove only one of the white, felt,
donut-shaped gaskets from the
inside of the purifier body.
donut-shaped gaskets from the
inside of the purifier body.
Step 6
Replace the gasket that had been
removed in STEP 4.
removed in STEP 4.
Step 2
With a #2 Philips screw driver,
remove the four screws from the
bottom of the unit.
remove the four screws from the
bottom of the unit.
Step 8
Replace the four screws
Step 7
Place lid back to its proper position
by aligning the arrow with the rear
seam.
by aligning the arrow with the rear
seam.
Step 9
Turn the unit back onto its wheels.
It is now ready for immediate use.
It is now ready for immediate use.
The AllerAir 600 models ship with their large carbon filters in a separate box.
This is done to safeguard your unit during shipping. To insert the filter, refer to the diagram below.
This is done to safeguard your unit during shipping. To insert the filter, refer to the diagram below.
AllerAir Industries Inc.
Toll free: 1-888-852-8247 / Fax: 1-877-688-3939 www.allerair.com
INSTALLING FILTER ASSEMBLY- 600 Models
(except D and DX)
The AllerAir 600 models ship with their large carbon filters in a separate box.
This is done to safeguard your unit during shipping. To insert the filter, refer to the diagram below.
This is done to safeguard your unit during shipping. To insert the filter, refer to the diagram below.
AllerAir Industries Inc.
Toll free: 1-888-852-8247 / Fax: 1-877-688-3939 www.allerair.com
Step 3
Gently grasp wheels.
Step 1
Turn Power Off and
unplug receptacle.
Lay unit upside down.
unplug receptacle.
Lay unit upside down.
Step 4
Remove base by gently pulling on
the wheels.
the wheels.
Step 5
First remove the HEPA filter by
placing thumbs on the inner side of
the filter.
Then pull up gently until totally out.
placing thumbs on the inner side of
the filter.
Then pull up gently until totally out.
Step 6
Than remove the Carbon filter by
placing thumbs on the inner side of
the filter.
Then pull up gently until totally out.
placing thumbs on the inner side of
the filter.
Then pull up gently until totally out.
Step 2
With a #2 Philips screw driver,
remove the four screws from the
bottom of the unit.
remove the four screws from the
bottom of the unit.
Step 8
Place lid back to its proper position
by aligning the arrow with the rear
seam.
by aligning the arrow with the rear
seam.
Step 9
With a screw driver, place 4
screws back into their positions.
Gently return the unit into
upright position.
screws back into their positions.
Gently return the unit into
upright position.
Step 7
Replace filters with new ones then
reassemble by inserting the Carbon
filter first then the HEPA filter.
reassemble by inserting the Carbon
filter first then the HEPA filter.