Harbor Freight Tools 47821 ユーザーズマニュアル
skU 47821
For technical questions, please call 1-800-444-3353
Page 15
PROGRAMMING
The remote Control (C) transmitter comes pre-programmed from the fac-
tory. Changing the transmitting codes should only be done if absolutely
necessary.
The remote Control Transmitter has two buttons.
The T1 button is used to open and close both of the Gate Wings.
The T2 button can be programmed and used to open one Gate Wing.
Both buttons are used to program the remote Control transmitter.
tory. Changing the transmitting codes should only be done if absolutely
necessary.
The remote Control Transmitter has two buttons.
The T1 button is used to open and close both of the Gate Wings.
The T2 button can be programmed and used to open one Gate Wing.
Both buttons are used to program the remote Control transmitter.
Example Code Chart
1
2
3
4
5
6
7
8
9
10 11 12
ON
(T2)
X
X X X
X X
Off
(T1)
X X
X X X
X
ExamplE
Programming the T1 Button - Remote Control
1.
Using the T1 chart to the right, mark one
block either (on) or (off) in all twelve
columns – see also Example Chart.
This will be the new twelve-button code
sequence that is assigned to the T1
button on the controllers.
columns – see also Example Chart.
This will be the new twelve-button code
sequence that is assigned to the T1
button on the controllers.
2.
next press and hold both buttons (T1 & T2) until the lEd stops flashing, turns off and
turns back on. now the remote is in Programming Mode. note: The remote will remain
in Programming Mode until a twelve button code sequence is entered; i.e. the twelve-
button code sequence from the chart above.
in Programming Mode until a twelve button code sequence is entered; i.e. the twelve-
button code sequence from the chart above.
3.
Press and hold the T1 button until the lEd turns on. The T1 button is now ready to be
reprogrammed. (if you release the button before the lEd turns on, repeat this step.)
4.
next, press the first button in the T1 twelve-button code sequence from the chart above
(using T2 for on and T1 for oFF). Be sure to hold down the button until the lEd turns
on. Continue to enter the rest of the sequence in this manner until all twelve have been
entered. once the twelve-button code has been entered successfully, the remote will
automatically return to its normal operating mode, indicated by the lEd blinking while
either button is pressed.
on. Continue to enter the rest of the sequence in this manner until all twelve have been
entered. once the twelve-button code has been entered successfully, the remote will
automatically return to its normal operating mode, indicated by the lEd blinking while
either button is pressed.
noTE: if you make a mistake while entering the coded sequence, continue entering the original
code until all twelve are entered, signified by the lEd blinking while button is pressed.
Then repeat steps 2- 4 to restart the reprogramming process.
Then repeat steps 2- 4 to restart the reprogramming process.
Programming the T1 Button - Control Panel
The following steps program the control panel to open both gates when the T1 button (pro-
grammed above) is pressed.
grammed above) is pressed.
1.
Before any new codes can be programmed the old ones have to be cleared. To clear
T1
(Off)
T2
(On)
T1
(Off)
T2
(On)
T1 Code Chart
1
2
3
4
5
6
7
8
9
10 11 12
ON
(T2)
Off
(T1)
T1 Code Chart
1
2
3
4
5
6
7
8
9
10 11 12
ON
(T2)
Off
(T1)