Kidde KN-COPP-B ユーザーズマニュアル

(cont.)

•

Do not install in dead air spaces such as peaks of vaulted
ceilings, or gabled roofs.

•

Do not install in turbulent air from ceiling fans. Do not place
near fresh air vents or close to doors and windows that open
to the outside.

•

Keep the CO alarm away from excessively dusty, dirty, or
greasy areas such as kitchens, garages and furnace rooms.
Dust, grease and household chemicals can affect the sensor.

•

Keep out of damp and humid areas such as the bathroom.
Avoid spraying aerosols near the CO alarm.

•

Do not install in areas where the temperature is below 40
degrees Fahrenheit (4.4° Celsius) or hotter than 100 degrees
Fahrenheit (37.8° Celsius) during use. This unit can be stored
to -10 degrees Fahrenheit without harm to the alarm but it
must be above 40 degrees Fahrenheit for use.

•

Do not place behind curtains or furniture. CO must be able
to reach the sensor for the unit to accurately detect CO.

•

DO NOT locate Alarm within 5 feet (1.5 meters) of any 
cooking appliance.

•

that certain conditions can result in transient CO

situations, such as: i) Excessive spillage or reverse venting of
fuel-burning appliances caused by: 1) outdoor ambient condi-
tions, such as wind direction and/or velocity, including high
gusts or wind and insufficient draft in vent pipes; 2) negative
pressure differential resulting from the use of exhaust fans; 3)
simultaneous operation of several fuel-burning appliances
competing for limited internal air; 4) loose vent pipe connec-
tions from fuel-fired appliances; 5) obstructions, or unconven-
tional vent pipe designs which can amplify the above situa-
tions; 6) poorly designed and maintained chimneys and/or
vents; ii) extended operation of unvented fuel-burning devices
(range, oven, fireplace, etc.); iii) temperature inversions which
can trap exhaust near the ground; and  iv) car idling in an
open or closed attached garage, or near a home.

1. Using the template provided (see 

page 25). Mark the location on wall.

2. Insert the two screws provided until 

the screw heads are approximately 
1/8” from wall. (If mounting in 
plaster board or drywall, drill 3/16”
hole and use the plastic anchors 
provided.)

3. Hook the Kidde CO Alarm unit over the screws onto keyholes in back 

of unit.

The digital model may also be  placed on a tabletop. Simply fold out the
stand located on the back of the unit and place in a location that is easily
visible.

Two self adhesive labels are included with the CO alarm. Add the phone
number of your emergency service provider in the space provided. Place
one label next to the alarm and one label near a fresh air source such as a
door or window.

The following suggestions are intended to help you with the
placement and installation of your Kidde CO Alarm.

•

When wall mounting, place out of the reach of children.
Under no circumstance should children be allowed to 
handle the CO alarm.

•

Install in a sleeping area.

•

Placing at eye level allows for optimum monitoring of 
the digital display.

•

Insure that all vents of the unit are unobstructed.

•

For tabletop mounting we recommend the unit be 
placed no higher than three feet from the floor.