Lennox Hearth RAD35C-2 プリント

Note:    Do not operate fireplace without the eyebrow installed in its normal

position. See

Figure 1 for models with louvers or Figure 2 for

models with clean face panel.

Step 1. Grasp  the  existing  eyebrow  and  pull  it  forward  away  from  the

fireplace (it is held in place by spring tension). See

Figure 1.

Step 2. Slightly lift and pull the existing top louver assembly away from

the fireplace.

Step 3. Slide the existing eyebrow into the slots on the lower edge of the

top radiant replacement panel.

Step 4. Hang  the  top  radiant  panel/eyebrow  assembly  in  the  opening

previously occupied by the top louver assembly. See

Figure 2.

Step 5. Open the bottom louver assembly by pushing in simultaneously

the left and right sides of the louver assembly (the assembly is

hinged at the bottom).

Step 6. Merit Series Units - Remove the assembly from the fireplace by

removing the hinge screw and spacer on each end of it.

Merit Plus and Elite Series Units - Remove the assembly from the

fireplace by sliding the hinge pin, located at the door’s left side,

to the right until it disengages from the left corner post hole. Pull

the door diagonally to the left, away from the fireplace.

Step 7. Snap the replacement Lennox nameplate logo into the 2 holes

provided in the replacement panel.

Step 8. Merit Series Units - Install the replacement bottom radiant panel

using the existing hinge screws and spacers.

Merit Plus and Elite Series Units - Install the replacement bottom

radiant panel by inserting the right side locating pin into the right

cabinet corner post and then the left side spring-loaded pin into

the left cabinet corner post.

These clean face panel kits may be used with Merit

, Merit Plus

or

Elite® series gas fireplaces listed in Table 1.

INSTALLATION INSTRUCTIONS FOR CLEAN FACE PANEL KITS FOR USE WITH

™,

™

LENNOX HEARTH PRODUCTS

KITS AND ACCESSORIES

Printed in U.S.A. © 2001 by Lennox Hearth Products

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and the discontinuance of colors, styles and products.

Consult your local distributor for fireplace code information.